D-Link DSL-2540B - ADSL2/2+ Modem With EN Router Quick Install Manual - Ok.
10
D-Link DSL-540B Quick Install Guide
7. If prompted to restart your computer with the new settings, click
OK.
8. After your computer restarts, click on the
Network and Dial-up
Connections icon again, and right click on the Local Area
Connection icon and then select Properties.
9. In the Local Area Connection Properties dialog box, select
Internet Protocol (TCP/IP) and then click on Properties.
10. In the Internet Protocol (TCP/IP) Properties dialog box, click in
the radio button labeled
Use the following IP address and type
192.168.1.x (where “x” is any number between 2 and 254) and
255.255.255.0 in the IP address field and Subnet Mask field.
11. Click
OK twice to save your changes and then close the Control
Panel.
Windows
®
XP
1. In the Windows taskbar, click on the
Start button then go to
Control Panel and then click Network Connections.
2. In the
Network Connections window, right click on the Local
Area Connection icon and click on Properties.
3. Listed in the
Local Area Connection window are the installed
network components. Make sure the box for Internet Protocol
(TCP/IP) is checked and then click on
Properties.
4. In the Internet Protocol (TCP/IP) Properties dialog box, click on
the radio button labeled
Use the following IP address and type
192.168.1.x(where x is any number between 2 and 254) for the
IP address field and 255.255.255.0 for the Subnet Mask field.
5. Click on
OK twice to save your changes and then close the Control
Panel.