D-Link DSL-2540B - ADSL2/2+ Modem With EN Router Quick Install Manual - Configuring Your Computer
D-Link DSL-540B Quick Install Guide
Prior to accessing the router through the LAN or USB port, note the
following necessary configurations:
• Your PC’s TCP/IP address: 192.168.1.x(where “x” is any number
between 2 and 254)
• The router’s default IP address: 192.168.1.1
• Subnet mask: 255.255.255.0
Below are the procedures for configuring your computer. Follow the
instructions for the operating system that you are using.
Configuring Your Computer
Windows
®
2000
These are instructions for configuring a Windows
®
2000 operating
system. If you are using Windows
®
XP please proceed to page 9.
1. In the Windows taskbar, click on the
Start button and point to
Settings > Control Panel > Network and Dial-up Connections
(in that order).
2. Click on
Local Area Connection. When you have the Local Area
Connection Status window open, click on
Properties.
3. Listed in the window are the installed network components. If
the list includes Internet Protocol (TCP/IP), then the protocol has
already been enabled, and you can skip to Step 10.
4. If Internet Protocol (TCP/IP) does not appear as an installed
component, then click on
Install.
5. In the Select Network Component Type window, click on
Protocol
and then the
Add button.
6. Select Internet Protocol (TCP/IP) from the list and then click