D-Link DSL-2750E User Manual - Ethernet Card
ETHERNET Card
Computer is connected to D-Link DSL-2750E through the ETHERNET port on D-Link
DSL-2750E. Ensure your computer is configured with ETHERNET Adapter as well as
ETHERNET port. Besides, make sure you enabled the TCP/IP for your operating
system.
Connecting D-Link DSL-2750E
(1)
Place D-Link DSL-2750E in a safe and accessible location
Keep the device away
from heat source, power line or highly powered electronic equipment
where you
can easily view the LED indicator on the front panel of the device.
If you want to connect one or more telephones, Micro Filter is
needed; It will work between telephones and the line from phone
jack. For more details about connecting multiple telephones, please
refer to the FAQs
You are now ready to connect D-Link DSL-2750E. Follow these steps
;
1. Connect the ADSL Line – Plug one end of the telephone cable into the Line
port of splitter and insert the other end into the phone jack. Use another
phone cable to connect the DSL port of the splitter and the DSL port on the
rear panel of Router. Use Telephone set connect to PHONE port of the
splitter
2. Connect the power adapter – Connect the power adapter to D-Link DSL-
2750E and the mail supply. Power on the switch. The Power LED indicator
will turn on.
3. Connect D-Link DSL-2750E to your computer – Use the ETHERNET cable to
connect D-Link DSL-2750E and your computer
8