D-Link DSN-3200 - xStack Storage Area Network Array Hard Drive Quick Installation Manual - Installing The Dsn-3200
D-Link DSN-3200/3400 Installation Guide
11
Installing the DSN-3200
Insert an Ethernet crossover cable
into the management port of the
DSN-3000 series and connect the
other end to your management
system’s open Ethernet port (the
one set to IP address 192.168.1.2).
Note: The management port of
the DSN-series does not support
MDI and will require a crossover
cable. Or if you wish, two standard
straightthrough cables may be used
with an intermediate switch or hub.
The management port is 100MbE.
Insert an Ethernet cable into Host
Network Connection #0 of the
DSN-3000 series as identified on
page 6 and the other end to a 1GbE
port of your SAN network.
Insert each of the three power
cables into the power supply as
shown below. Then plug the other
end of these power cables into a
reliable filtered power source such
as a UPS (Uninterruptible Power
Supply).
1
2
3
Proceed to Software Installation Overview for
the DSN-3000 series.