D-Teg Smarty BX4000 User Manual - page 7
OPERATION
1. Make sure that the power cable is properly connected and turn on the car
power.
2. Blue LED & Red LED will turn on and slowly blinking simultaneously and
then Blue LED will remain on. Blue LED light means BX4000 is now ready
for the event recording and is started the Normal recording (Continuous
recording).
3. The normal recording (Continuous recording) will be automatically started,
if it set with your PC.
4. The event recording will automatically begin when triggered by Motion
Detection, Alarm1 to 3 or by the G-sensor and will begin with one short
“Beep” sound.
5. The panic recording can be started by pressing the [PANIC] button.
Removing the SD memory card
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, take out the SD memory card.
Inserting the SD memory card
System Error Buzzer
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, insert the SD memory card.
System Error Buzzer
A “Beep” “Beep” sound will occur and the BLUE & RED LED light will blink
simultaneously when there is a system error or SD card is not inserted.
[Check the SD memory card when this occurs. To solve the problem, initialize
the SD card or replace the SD card]
12
OPERATION
Press [PLAY] button then the INFORMATION OSD (the summery of setting)
will show up on the monitor as below,
INFORMATION OSD
CAM1
CAM2
CAM3
Activated
Record Mode
Normal
Normal
Event
√√
√√
√√
CAM4
Event
√√
System : NTSC
Quality : Super
Overwrite : ON
G‐Sensor Level : X:3 Y:3 Z:3
Resolution : 720X480
FPS : 5
Audio : ON
G Sensor Level : X:3, Y:3, Z:3
G‐Sensor Calibration :
Firmware Version : 2.0.1
Current Time : 14:50:07 07 JUL 2011
√√
To change the live display channel, press [PANIC] button.
The INFORMATION OSD will be turned off automatically after 30 seconds.
To turn off the live view press [PLAY] button or [SHUTTER] button
To turn off the live view, press [PLAY] button or [SHUTTER] button.
LIVE VIEW
Turn on the BX4000 and press [PLAY] button to turn on the INFORMATION OSD
(th
f tti ) T h
th li di l
h
l
[PANIC]
(the summery of setting) . To change the live display channel, press [PANIC]
button to select the camera. And then press [PLAY] or [SHUTTER] button to
escape.
CAM 1 => CAM 2 => CAM 3 => CAM4 => 4 Cameras together
13
12
13