Da-Lite IDEA Panoramic Instruction Book - page 4
4
Middle Panel
Viewing Surface
#8 x 1/2” Screws
Middle Aluminum Tray
Side Aluminum Tray
Side Aluminum Tray
Groove of Frame
Tray Connecting Plate
Assembly (continued)
6. Center middle aluminum tray with the top of the vertically
upright middle panel and attach with (5) #8 x 1/2” screws. Insert
screws through the tray into the groove of the frame (Figure 2a).
Note:
The length of the middle tray is the same as the length of
the middle panel.
7. Align each side tray with the middle tray and attach to the top of
the vertically upright frame with (5) #8 x 1/2” screws per tray. Insert
screws through the tray into the groove of the frame. Screws
should only be inserted halfway at this time, keeping the tray
loose.
8. Join the tray sections by attaching a connecting plate between
the middle tray and each side tray. Align the tray sections
and secure with (2) 10–32 nuts. Tighten both
nuts into each plate (Figure 2b).
Figure 2a
Note: Straight and even alignment of the tray sections will
maintain rigidity of the screen assembly when installed on
the wall.
9. Tighten the screws for each tray into the bottom of the frame
(Figure 2a).
10. Place screen assembly back down on the clean work area,
viewing surface up..
Figure 2b
10-32 Nuts