Dacor CM24PBISAS Installation Instructions Manual - Nstallation
I
nsTallaTIon
I
nsTruCTIons
• Connect the other end of the hose to to the coffee
system water inlet. Make sure it is secure.
• Attach the quick-release fitting to the hose fitting.
• Turn on the water supply valve. Check for leaks.
Pressure Regulator:
IMPORTANT: The setting on the pressure regulator may
not exceed 3.0 bars/43.5 psi (1.5 bars/21.8 psi minimum).
• Look through the window on the left side of the unit to
read the pressure setting.
To adjust the output:
• Pull the pressure regulator control knob out slightly.
• Turn it clockwise to increase the output pressure. Turn
it counter-clockwise to reduce the pressure.
• After adjustment, gently push the control button back
in.
p
lumbIng
I
nsTallaTIon
(m
oDel
Cm24pbIsas o
nly
)
CAUTION
To prevent damage to the coffee system due to hard water,
prior to installation, check the water hardness for the building
where you will be installing the coffee system (see page 3). If
necessary have a qualified water treatment specialist install a
water treatment system. The water treatment system must be
installed between the house plumbing and the coffee system
regulator.
• With the main water valve closed, attach the hose
fitting to the house plumbing. You can use the supplied
1/4” compression fitting to connect the quick connect to
a 1/4” hose or water line (see below).
IMPORTANT: Connection to a house water supply with
a diameter larger than 1/4” requires an adapter (not
supplied). The adapter needs to have a 1/4-19 BSPP
female thread to connect to the quick release.
• Cut a section of the supplied Teflon hose long enough
to connect between the coffee system water inlet and
the house water connection, without binding or kinking.
• Insert one end of the Teflon hose into the quick-release
fitting. Make sure that it is secure.
Coffee System
Water Inlet
Back of Coffee
System
Teflon Hose
Hose Fitting
Quick Release
Connector to
Coffee System
House Water Connection
Window
Regulator
Adjustment