Installation instructions discovery wall oven for use with models eo, mo and po part no. 65433 rev. J preliminary - for review only no scheduled release date.
All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 dacor, all rights reserved..
1 planning the installation ................................................... 6 selecting the location ...................................................... 6 cabinet cut-out ............................................................... 6 cabinet cut-out (continued) ...............................
2 important safety instructions read the accompanying use and care manual • before operating this appliance. Keep packaging materials away from children. • plastic sheets and bags can cause suffocation. If you receive a damaged product, immediately • contact your dealer or builder. Do not install or...
3 if you need help... If you have questions or problems with installation, contact your dacor dealer or the dacor customer service team. For repairs to dacor appliances under warranty call the dacor distinctive service line. Whenever you call, have the model and serial number of the appliance ready....
4 product specifications model number a b c d e f g h eo127 27” (686 mm) 27 15/16” (710 mm) 23 3/8” (594 mm) 2 5/16” (59 mm) 7 3/8” (187 mm) 6 3/8” (162 mm) 27 3/8” (695 mm) 25 3/8” (644 mm) po127 mov127 moh127 eo130 30” (762 mm) 28 3/8” (721 mm) po130 mov130 mov130 eo227 27” (686 mm) 51 1/16” (1297...
5 g d e f c 66” (1676 mm) flexible conduit a b 1 1/4” (32 mm) h chassis notch side view control panel front top of chassis top of chassis utility cutout l k j g d e f c 66” (1676 mm) flexible conduit a b 1 1/4” (32 mm) h chassis notch side view control panel front top of chassis l k top of chassis u...
6 a b 4“ typical toe kick (shown) 3/4” (19 mm) support platform recommended electrical location 9 5/8” (244 mm) recommended (may be altered) 1 ¾“ (45 mm) min. Clear to top of door for heat exhaust 1“ (25 mm) min. Clear to bottom of door c c a b 4“ typical toe kick (shown) alternate electrical locati...
7 alternate electrical locations 4“ (102 mm) min. Between cutout recommended electrical location 4“ typical toe kick (shown) 1“ (25 mm) min. To combustibles a b 3/4” (19 mm) support platform a b 3/4” (19 mm) support platform 36” typical (914 mm) 1 1/2” (38 mm) typical counter 1 ¾“ (45 mm) min. To co...
8 planning the installation cabinet cut-out (continued) support platform warning the top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or beco...
9 planning the installation electrical specifications important preheat times and cavity temperature recovery times • will be increased slightly if operating on less than a 240 vac circuit. This appliance is provided with electrical connec- • tion leads in a flexible metal conduit. These leads may b...
10 installation instructions before proceeding, turn off power to the circuit to which 1. The oven will be connected at the circuit breaker or fuse box. Position the oven directly in front of the cabinet cutout. 2. Feed the appliance conduit into the electrical junction 3. Box and attach it using a ...
11 installation instructions connecting to a three wire electrical system - where local codes permit warning do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building codes permit. Separate the wires coming out of the appliance conduit. 1. Connect...
12 installation instructions final installation warning a minimum of two people are required to safely • install this appliance. Do not attempt to disengage the hinge catches with • the door removed from the oven. The hinge springs could release, causing personal injury. Do not lift or carry the ove...
13 raise the door so that it is at a 15° angle from the front 3. Of the oven. Hold the door with one hand on each side. Lift the door up and out. Install the oven in the cabinet warning use an appliance dolly to move the appliance when • installing it or removing it from the wall for service. Use of...
14 grasp the oven door on opposite sides and hold it at a 1. 15° angle from the front of the oven. See facing page. Slide the hinges into the hinge openings, resting the 2. Bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand 3. While pushing in o...
15 installation instructions door installation installation checklist warning to ensure a safe and proper installation, the follow- • ing checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the ho...
16 notes.
Dacor●600antonblvd.Suite1000costamesa,ca92626●phone:(800)793-0093●fax:(626)403-3130●www.Dacor.Com.
