Dacor EPICURE EG366 Installation Instructions Manual - page 6
4
ElEctrIcal rEquIrEmEnts
It is the owner’s responsibility to ensure that the electrical
•
receptacle for this appliance has been installed by a qualified
electrician. The electrical installation, including minimum
supply wire size and grounding, must be in accordance with
the National Electric code ANSI/NFPA 70-1993* (or latest
revision) and local codes and ordinances. A copy of this
standard may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
The correct voltage, frequency, and amperage must be
•
supplied to the appliance from a separate, grounded circuit
that is protected by a properly sized circuit breaker or time
delay fuse. Refer to the chart below for requirements.
eLecTrIc cIrcuIT reQuIreMenTS
circuit required
Total connected Load
120 Vac
60Hz, 15 Amp
24.0 W (0.2 Amp)
G
as
s
upply
R
equiRements
Check your local building codes for the proper method of
•
installation. In the absence of local codes, this appliance
should be installed in accordance with the National Fuel Gas
Code ANSI Z223.1.
Be certain that the appliance being installed is correct for the
•
gas service being provided (natural gas or LP gas). Also, if
operating the cooktop at an altitude above 4000 ft. (1219 m)
make sure it is equipped for high altitude operation.
See the table below for gas supply pressure requirements.
•
Make sure the gas supply meets minimum requirements.
The regulator inlet accommodate
•
s a 3/4” gas line. The inlet to
the cooktop itself is equipped with a 3/4” male NPT fitting.
GaS SuPPLY PreSSure reQuIreMenTS
Gas Type
Manifold Pressure
Minimum Gas
Supply Pressure
Natural Gas
5” Water Column
6” Water Column
Propane (LP)
10” Water
Column
11” Water Column
product dImEnsIons
plannIng thE InstallatIon
cooKToP WIDTh (a)
EG366
35 7/8” (911mm)
EG486
47 7/8” (1216mm)
IMPorTanT: Observe all governing codes and ordinances during planning and installation. Contact your local building department
for further information.
WarnInG
All tolerances: +1/16”, -0 (+1.6mm, -0)
SIDe vIeW
A
Rear of trim to front of knobs
B
Rear of trim to front of bull nose
C
Rear of trim to front of control panel
D
Bottom of chassis to bottom of trim
B
27” (686mm)
A
28” (711mm)
D
7 3/4”
(197mm)
4” (102mm)
5/8” (16mm)
C
26” (660mm)
A
Power cord
36” long