Dacor Epicure ER36D Installation Instructions Manual - Nstallation
I
nsTallaTIon
I
nsTruCTIons
Installing the optional Backguard, or Island
Trim
WarnInG
WarnInG: Do not operate the range without the shipping
cover, optional island trim, or backguard installed.
noTe: Dacor
®
recommends that the 24-Inch backguard be
installed by at least two people.
To install the optional island trim or backguard:
Remove the single screw on the front of the shipping cover.
Slide the shipping cover off the unit.
Remove the stainless steel trim piece and the backguard or
island trim from its box.
24-Inch backguard only: Use eight (8) hex screws from the
backguard kit to attach the support brackets to the range
chassis. Make sure the gas line is positioned under the
bracket as shown below.
1.
2.
3.
4.
To avoid scratches, place small scraps of thin cardboard on
the rear of the side panels where the island trim/backguard
will make contact. Place the island trim/backguard over the
back of the range. Special attention should be given to the
lower flange in front of the island trim/backguard, which
must fit between the stainless steel side panels and over the
stainless steel trim piece (see range side detail below). on
the 24-Inch backguard: The “C” channels on the backguard
slide into the brackets on the range chassis.
5.
Shipping cover Screw
Shipping cover Screw removal
Front of
range
Spill Tray
cooktop
chassis
Stainless Steel
Trim Piece
range Back
cover
Back of
Backguard/
Island Trim
Front Flange
of Backguard/
Island Trim
range Side Detail
Sliding the Backguard into Place
hex Screw,
8 Places
Support Bracket Installation for 24-Inch Backguard
Gas Line