Dacor ER30D Installation Instructions Manual - Warning
9
Changing the Backguard (models ER30D
and ER30D-C only)
Models ER30D and ER30D-C come standard with a 3” backguard
installed. The 6” backguards is optional. Install according to the
instructions included with the backguard.
Installing the ATK30SR Downdraft Vent Trim
Kit (model ER30DSR only)
To install the optional downdraft vent with self-rimming model
ER30DSR, you must install the optional downdraft vent trim kit.
Install according to the instructions included with the kit.
Installing a Downdraft Vent (Optional)
Install the PRV30 downdraft vent before final installation of the
range. See the installation instructions included with the downdraft
vent.
IMPORTANT:
The downdraft vent attaches to the narrow back
portion of the downdraft vent/range cutout. It is self-supporting in
the cutout and does not actually attach to the range itself.
Installing the Anti-Tip Bracket on the Floor
WARNING
To perform its intended function, the anti-tip bracket must be
attached as instructed to the concrete slab or wood sub-floor
below any floor coverings (including cement board) on top. Do
not attach the anti-tip bracket directly to floor coverings such as
ceramic/asphalt tile or linoleum.
1. Locate the anti-tip bracket included in the parts box.
2. Install the anti-tip bracket on the floor using the four (4)
included screws. See the diagram below for location.
NOTE:
If the floor is wood, use wood screws instead (not included).
ANTI-TIP BRACKET PLACEMENT
A
6 5/8” (16.8 cm)
B
6 3/8” (16.2 cm)
Installation Instructions
B
Right side
of range
Back of
range
Top view
Bracket
A
Removing the Oven Door
WARNING
•
Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
•
Do not lift or carry the oven door by the handle.
To make the range easier to move, remove the door to reduce
weight.
1. Open the door to its fully opened position.
2. Rotate the catch over the retaining arm on each hinge.
3. Lift the oven door to about a 15° angle from the vertical
position.
4. Hold the door with both hands just below the handle and pull
it away from the oven while continuing to lift.
Catch
Retaining arm
Door Gripping Points