Dacor ER30D Installation Instructions Manual - Warning
12
Electrical Connection (cont.)
Connecting the Conduit to the House
Electrical Junction Box
WARNING
•
Do not ground the appliance to a gas supply pipe or hot
water pipe.
•
Do not turn on power to the appliance until the range is
permanently grounded.
•
A grounded cold water pipe must have metal continuity to
electrical ground and must not be interrupted by insulating
materials. Any insulating materials must be jumpered with a
length of No. 4 copper wire securely clamped to bare metal
at both ends.
IMPORTANT:
The power supply must be properly polarized.
Reverse polarity will result in continuous sparking of the
electrodes, even after flame ignition. If there is any doubt as to
whether the power supply is properly polarized or grounded, have
it checked by a licensed electrician.
1. With the range positioned directly in front of the cabinet
cutout, feed the appliance wires into the junction box.
Depending upon local codes, utilize one of the three (3)
methods shown to connect the appliance to the junction box.
2. Connect the white wire from the appliance to the neutral
(white) supply wire in the junction box.
3. Connect the black wire from the appliance to the black (L1)
power supply wire in the junction box.
4. Connect the red wire from the appliance to the red (L2) power
supply wire in the junction box.
5. If using a 4 wire connection, connect the green wire to a
grounded supply wire in the junction box or to a grounded
cold water pipe. If connecting to a grounded cold water pipe:
◊
Use a separate copper grounding wire (No. 10 minimum)
to connect to the cold water pipe by means of a clamp
and an external grounding connector screw.
◊
If there are any materials that isolate the cold water pipe
from ground, jumper it with a No. 4 copper wire, clamped
on both ends.
6. Replace the junction box cover.
Installation Instructions
RED
RED
GREEN
WHITE
WHITE
BLACK
BLACK
GREEN
Connection to
power supply
Connection to
power supply
Wire nut
3 places
Wire nut
4 places
Junction box
Junction box
3 Wire Conduit Connection
to Junction Box
4 Wire Conduit Connection
to Junction Box
Connection to appliance
(Page 10)
Connection to appliance
(Page 10)