Dacor Millennia MDW24S Installation Instructions Manual - Nstallation
3
I
NSTALLATION
S
PECIFICATIONS
I
NSTALLATION
T
IPS
Please read all safety instructions before installing your new
dishwasher.
WARNING
WARNING –
Electric Shock Hazard: Disconnect electrical
power at the fuse box or circuit breaker box before beginning
installation. Failure to follow this warning could result in death
or serious injury.
•
Examine the dishwasher and locate the connections.
See
Locating the Connections.
•
Locate dishwasher where there is easy access to drain,
water, and electrical lines. The best location is on either
side of the kitchen sink for access to existing plumbing
and ease in loading dishes.
See Making the Connections,
pages 4-5.
•
Electrical, water and drain connections are not the same for
all age, brands or models of dishwasher. Check the location
and length of home utilities.
See Making the Connections,
pages 4-5.
•
A 15-20 amp, grounded 120 volt AC only electrical supply is
required.
See Making the Connections, pages 3-5.
•
If the dishwasher drain hose will be connected to a food
disposer for the first time, remove knock out plug covering
disposer inlet.
See Making the Drain Connection, page 5.
•
Kinked water and drain hoses can cause problems.
See
Finishing the Connections, page 7-8.
•
Dishwashers need to be connected to a hot water supply
with enough water pressure to ensure an adequate fill.
See
Making the Water Connection,
page 4.
•
Each home installation differs. You will need additional
parts listed above to complete the installation.
See
Materials Not Included But Needed For New Installations,
page 2.
•
Flush water line prior to making the final connection
to prevent clogging of the inlet valve filter screen.
See
Finishing the Water Connection, page 7.
•
The dishwasher will look, sound and perform best when
properly leveled.
See Leveling the Dishwasher, page 7.
•
Anchor the dishwasher to the countertop and adjacent
cabinets.
See Securing the Dishwasher, page 9.
G
ETTING
S
TARTED
WARNING
WARNING –
Electric Shock Hazard:
-
Observe all local codes
and ordinances for electrical and plumbing connections. All
electrical and plumbing work should be performed by qualified
persons. Failure to follow this warning could result in death or
serious injury.
WARNING
WARNING –
Electric Shock Hazard:
-
Electrical, water and
drain lines must be confined to shaded areas in Figure 1.
Electric conductors, water and drain could be damaged.
Failure to follow these instructions could result in fire or
electric shock.
90º
90º
34 1/4” min
24” min
7 1/2”
1 1/2”
6”
24”
Hot
Water
Line
Electrical
Wiring
18”
4”
6”
1 1/2”
Electrical,
water, and
drain lines
must be
confined to
shaded area
1
Make sure your location has the right drain, water and
electrical outlets to make connections. Do not install unit
under a cooktop. Damage may occur.
2
Remove any carpet from area to provide clearance. Floor
should be flat and free from any obstructions.
NOTE:
For proper operation and appearance of the unit, cabinet
opening should have dimensions as shown in Figure 1.
If unit is to be placed in a corner, there must be at least 2
inches between the opened door and the wall in order to
open the door.
Drain, water and electrical lines should be roughed-in
before going any further.
If the dishwasher is installed at the end of a cabinet line, the
dishwasher sides and back must be fully enclosed.
L
OCATING THE
C
ONNECTIONS
NOTE:
Do not cross drain, water and electrical lines in front of
dishwasher motor or frame.
Disconnect power at breaker box before starting
installation.
FIG 2