Dacor Renaissance RNTT365GB Use And Care Manual - page 11
9
Setting the Clock
1. Make sure the cooktop is on (the burner dis-
plays are lit).
• If necessary to power on, Touch the ON/OFF
button for two seconds.
2. Touch the clock and lock buttons for at
least 3 seconds. The current time appears on
the display (hours will be flashing).
3. Touch the clock “—” and “+” buttons (to
the right of the clock button) to set the hours.
4. Touch the clock button. The minutes will begin
to flash.
5. Touch the clock “—” and “+” buttons to set
the minutes.
6. Save the settings: Touch the clock button to
set the changes.
7. The current time mode appears on the display
(hours will be flashing).
Locking the Control Panel
You can lock the control panel to reduce the
chance of a burner being turned on unintentionally
or to make it more difficult for children to operate
the controls.
Refer to the Burner Control diagram during these
instructions.
IMPORTANT: The cooktop must be off (the
burner displays not lit) to activate the control
panel lock.
To lock the control panel:
1. Touch and hold the lock button for
about 3 seconds.
• The control panel will beep, and a
• decimal point will appear on all burner
displays.
This confirms the control panel is locked.
To unlock the control panel:
1. Touch and hold the lock button for
about 3 seconds.
• The control panel will beep, and the
• decimal points will disappear from the burner
displays.
• The control panel is unlocked.
Operating Your Cooktop
Clock Button
Lock
Button
Clock “+”
Button
Clock “—”
Button
Clock
Button
Burner Control
Burner display
Lock Button
Lock Button
ON / OFF
Button
Clock-Setting Buttons
Control Panel Buttons: Clock Setting
Lock
Button
Left Front
Burner
Sear
Burner
ON / OFF
Button
Control Panel Buttons: Panel Locking
Control Panel Lock Buttons + Display
Left Rear
Burner