Dacor Renaissance RNTT365GB Use And Care Manual - page 14
12
Before You Call for Service
Display Codes
Burner Control Display Codes
These codes may appear on one or more of the burner control displays.
Code
What it Means
What to Do
“b” = a burner is locked.
Burner failed to light after
three tries.
Reset burner according to instructions on
page 7. If error code occurs again, see
No flame on following page.
“F”=Flame abnormality.
Safety sensor for that burner
has detected abnormal flame.
Check to make sure the burner ring and
burner cap(s) are properly assembled. Reset
burner according to instructions on page
7. If error occurs again, call for service.
Burner is (very) HOT.
Not an error code. “H” warns the user that
the burner is HOT after use. “H” will disap-
pear after the burner has cooled.
Clock Display Codes
These codes may appear on the clock display.
Error Code
What it Means
What to Do
Flt00, Flt01, Flt02,
Flt03, Flt04, Flt04,
Flt05
System malfunction detected
Unplug the power cable for 10
seconds, then reconnect. Attempt to
operate cooktop normally. If error
code occurs again, disconnect power
and call for service.
Flt06
Limit of 5 burner resets in 15
minutes exceeded.
Wait 15 minutes for error code to
clear. Troubleshoot cooktop operation
according to No flame section on
following page, then perform a
burner reset if necessary. If one or
more burners continue to not light,
disconnect power and call for service.
Flt08, Flt09
System malfunction detected.
Unplug the power cable for 10
seconds, then reconnect. Attempt to
operate cooktop normally. If error
code occurs again, disconnect power
and call for service.
Flt0A
All burners are locked.
Try to reset burners according to
instructions on page 7. If control
panel will not reset, unplug the power
cable for 10 seconds, then reconnect.
If error code occurs continues, unplug
power and call for service. If error
code clears, check No flame on fol-
lowing page before attempting to use
appliance again.
Flt0[, Flt0E
System malfunction detected
Unplug the power cable for 10
seconds, then reconnect. Attempt to
operate cooktop normally. If error
code occurs again, disconnect power
and call for service.