Dacor Renaissance RNTT365GB Use And Care Manual - page 15
13
Problem — Solution Guide
Problem
May Be Caused By
What to Do (Solution)
Nothing works
(display not lit).
Cooktop not connected to
electrical power.
Check to make sure power cord is
plugged into electrical outlet.
Power to electrical outlet is off.
Turn on power at circuit breaker panel
or fuse box. Check for tripped breaker
or blown fuse.
Power outage.
Contact power company.
Igniters do not spark.
Power not supplied to unit.
See Nothing Works problem above.
Cooktop turned off.
If burner displays do not show a
number, cooktop is off...touch ON/
OFF button to turn on. NOTE: clock
display is lit even when cooktop is off
(burner displays not lit).
Burner not activated properly.
Touch the “+” button for the desired
burner TWICE within four seconds to
light (this is a safety feature).
Wet or dirty igniter.
Clean and dry igniter and burner
assembly according to Care and
Cleaning section.
No flame
(burner does not light).
Power not supplied to unit.
See Nothing Works above.
Cooktop turned off.
If burner displays do not show a
number, the cooktop is off. Power
on: Touch ON/OFF button for two
seconds. NOTE: clock display although
cooktop is off (burner displays not lit
when off).
Burner not activated properly.
Touch the “+” button for the desired
burner TWICE within four seconds to
light (this is a safety feature).
Wet or dirty igniter.
Clean and dry according to Care and
Cleaning section.
Gas is turned off.
Make sure the gas supply valve is in
the on position.
Gas supply interrupted.
Contact gas company.
Burner goes out at low
setting.
Low gas pressure.
Contact gas company to have pressure
tested.
Before You Call for Service