Dacor Wall Ovens Installation Instructions Manual - page 9
Page 6
Page 7
STEP 9
Installing the Exhaust Grill
With the oven now secured to the cabinet, install the Exhaust Grill by mounting it to the oven
with the two screws provided.
Secure oven to
cabinet with
screws provided
Single Ovens – 4 screws
Double Ovens – 6 screws
Figure 12
Installing the cabinet mounting screws
Exhaust Grill
#8 Screw
Figure 13:
Attaching the Exhaust Grill
NOTE:
You may need to loosen
the side mounting
screws a little to align
the Exhaust Grill
mounting holes. Tighten
the side mounting
screws after attaching
the Exhaust Grill.
WARNING:
Failure to fully rotate the hinge catches will cause them to
bend when the door is closed. This will make closing the door
impossible.
STEP 10
Re-Installing the Oven Door(s)
Grasp the oven door on opposite sides and lift it until the door hinges are aligned with the openings in the oven frame. Holding the door at
about a 30˚ angle from the horizontal, slide the hinges into the openings until the
bottom hinge arms drop fully into the hinge receptacles. Lower the door to the fully opened position, and then rotate the two hinge catches
toward the oven. Open and close the door completely to ensure that it is properly installed.
For double ovens, complete STEP 11 for both the upper and lower doors.
For stainless steel ovens, peel off the protective layer of plastic that covers the door panel.
STEP 11
Verifying Oven Operation
Slide the oven racks onto the support racks within the cavity. Place the broiler pan and tray on a rack within the oven, if desired.
Turn on the power supply to the oven. Set the time of day by pressing the Clock touch pad then pressing the TIME•TEMP key.
Press the BAKE selector pad for the upper oven or single oven. Select a temperature of 350˚F by pressing the TIME•TEMP “+” key. The oven
should now be heating. After approximately three (3) minutes, the lower heating element should glow red. Press the CANCEL•SECURE pad
to stop the oven heating process. It may take longer than three (3) minutes when ovens are running at voltages lower than 240V. If checking
the operation of the double oven, repeat the bake test for the lower oven.
Press the BROIL selector pad for the upper oven or single oven. Select a temperature of 350˚F by pressing the TIME•TEMP “+” key. The oven
should now be heating. After approximately three (3) minutes, the upper heating element should glow red. Press the CANCEL•SECURE pad
to stop the oven heating process. It may take longer than three (3) minutes when ovens are running at voltages lower than 240V. If checking
the operation of the double oven, repeat the broil test for the lower oven.
NOTE:
You may need to loosen the side mounting screws a little to align the Exhaust Grill mounting holes.
Tighten the side mounting screws after attaching the Exhaust Grill.
WARNINGS:
If the oven does not operate properly, follow these troubleshooting steps:
1. Verify that power is being supplied to the oven..
2. Check the electrical connections to ensure that the installation has been completed correctly.
3. Repeat the above bake test.
4. If the appliance still does not work, contact an authorized DACOR service company at
(800) 772-7778. Do not attempt to repair the appliance yourself. DACOR is not responsible for
service required to correct a faulty installation.
WARNING:
Failure to fully rotate the hinge catches will cause them to bend when the door is closed. This will
make closing the door impossible.