Daewoo DSP-4210GM Instruction Manual - Preparation
2
• When a problem occurs,
immediately stop all operations.
•
Do not place any liquid container on top
of the Plasma Monitor. If water spills
into the Plasma Monitor, a short-circuit
may occur which could result in fire or
electric shock.
• Do not place any objects on top of the
Plasma Monitor. If any foreign objects
get inside, it can cause damage to or
premature failure of the unit.
•
When installing this unit on a wall or
ceiling, please consult an Authorized
Service Center. Improper mounting
can result in personal injury or
damage to the unit.
•
During a lightning storm, do not
touch the unit. Doing so may result
to an electric shock.
• Do not place the Plasma Monitor on
sloped or unstable surfaces. The
unit may fall off or tip over causing
injury and damage.
• Do not do anything that might
damage the power cable.
Damaging the power cable may
result in fire or electric shock.
• Do not handle the power cord with
wet hands. Doing so may cause
electric shocks.
• Do not overload wall outlets and
extension cords. Doing so may
result in power failure.
•
Do not make any modifications.
(Never attempt to disassemble this
unit yourself) The internal
components of this unit is high
voltage which may cause electric
shocks.
•
Do not place the Plasma Monitor in
sunlight or near heating units. Doing
so may cause damage to or cause
premature failure of the unit.
•
Do not cover the ventilation holes.
Doing so may cause the Plasma
Monitor to overheat, which can cause
fire or damage to the internal
components.
Preparation
IMPORTANT SAFETY INSTRUCTIONS