E-FLITE Carbon-Z Splendor Instruction Manual

Summary of Carbon-Z Splendor

  • Page 1

    Carbon-z tm splendor tm instruction manual - bedienungsanleitung - manuel d’utilisation - manuale di istruzioni.

  • Page 2

    En to register your product online, visit www.E-fliterc.Com warning: read the entire instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. This...

  • Page 3: Table of Contents

    En table of contents introduction specifications 5.50 lb (2.50 kg) 56.7 inches (1440mm) 54.5 inches (1380mm) bl50 brushless outrunner motor, 525kv installed 60-amp pro switch-mode bec brushless esc (v2) installed (4) 26 g digital mg mini servo (eflr7145) installed spektrum ™ ar635, 6-channel as3x sp...

  • Page 4

    En binding is the process of programming the receiver to recognize the guid (globally unique identifier) code of a single specific transmitter. You need to ‘bind’ your chosen spektrum ™ dsm2 ® /dsmx ® technology equipped aircraft transmitter to the receiver for proper operation. Please visit www.Bin...

  • Page 5: Low Voltage Cutoff (Lvc)

    En low voltage cutoff (lvc) installing the battery as3x system when a li-po battery is discharged below 3v per cell, it will not hold a charge. The esc protects the flight battery from over-discharge using low voltage cutoff (lvc). Before the battery charge decreases too much, lvc removes power supp...

  • Page 6: Arming The Esc and Receiver

    En arming the esc and receiver 1 2 arming the esc also occurs after binding as previously described, but subsequent connection of a flight battery requires the steps below. As3x the as3x system will not activate until the throttle stick or trim is increased for the first time. Once the as3x is activ...

  • Page 7: Factory Servo Arm Settings

    En 1. Slide the horizontal tail tube ( a) into the hole in the rear of the fuselage. 2. Install the 2 piece (left and right) horizontal tail as shown. 3. Install 2 short screws in the forward holes in the horizontal tail. 4. Install 2 long screws in the rear holes in the horizontal tail. 5. Attach t...

  • Page 8: Installing The Wings

    En 1. Remove the canopy hatch before installing the wings . 2. Slide the wing tube ( a) into the fuselage. 3. Install the left and right wing ( b and c) over the wing tube and into the wing slot of the fuselage while inserting the aileron servo connectors through the provided holes. 4. Invert the fu...

  • Page 9: Elev

    En assemble the aircraft and bind your transmitter to the receiver before performing this test. Activate the as3x system by advancing the throttle to 25%, then fully lowering the throttle. Move the aircraft as shown to ensure the as3x system moves the control surfaces in their proper direction. If t...

  • Page 10: Transmitter Setup

    En transmitter setup important: the ar635 receiver’s default setting is computerized transmitter 3d. We recommend that you do not change this setup. Refer to the receiver manual for more information. A dsm2/dsmx five-channel (or better) transmitter with adjustable dual rates and adjustable exponenti...

  • Page 11: Flying Tips and Repairs

    En flying tips and repairs always decrease throttle at propeller strike. Flying field always choose a wide-open space for flying your aircraft. It is ideal for you to fly at a sanctioned flying field. If you are not flying at an approved site, always avoid flying near houses, trees, wires and buildi...

  • Page 12

    En t guidelines for precision flying the e-flite splendor aircraft and its as3x system were designed together to help an intermediate pilot apply standard flying skills to precision flying. This aircraft excels in precision maneuvers. While the as3x system is activated, you can practice precision ma...

  • Page 13: Service of Power Components

    En disassembly 1. Remove the screw ( a) and spinner (b) from the collet (g). 2. Remove the spinner nut ( c), propeller (d), spinner back plate (e), backplate ( f) and collet from the motor shaft (h). You will need a tool to turn the spinner nut. 3. Remove 2 screws ( i) from inside the cowling (j). C...

  • Page 14

    En ama national model aircraft safety code please see your local or regional modeling association’s guidelines for proper, safe operation of your model aircraft. Effective january 1, 2011 a. General a model aircraft is a non-human-carrying aircraft capable of sustained flight in the atmosphere. It m...

  • Page 15: Troubleshooting Guide  As3X

    En problem possible cause solution oscillation flying over recommended airspeed reduce air speed damaged propeller or spinner replace propeller or spinner imbalanced propeller balance the propeller. For more information, view john redman’s propeller balancing video at www. Horizonhobby.Com flight co...

  • Page 16: Troubleshooting Guide

    En aircraft will not con- nect (after binding) to transmitter transmitter too near aircraft during connecting process move powered transmitter a few feet from aircraft, disconnect and reconnect flight battery to aircraft aircraft or transmitter is too close to large metal object, wireless source or ...

  • Page 17: Limited Warranty

    En limited warranty what this warranty covers horizonhobby,inc.(“horizon”)warrantstotheoriginalpurchaserthattheproduct purchased(the“product”)willbefreefromdefectsinmaterialsandworkmanship atthedateofpurchase. What is not covered thiswarrantyisnottransferableanddoesnotcover(i)cosmeticdamage,(ii) dam...

  • Page 18: Contact Information

    En declaration of conformity (in accordance with iso/iec 17050-1) no. Hh2012112203 product(s): efl carbon-z splendor bnf basic item number(s): efl10250 equipment class: 1 the object of declaration described above is in conformity with the require- ments of the specifications listed below, following ...

  • Page 19

    It country of purchase horizon hobby address phone number/email address united states of america sales 4105 fieldstone rd champaign, illinois 61822 usa 800-338-4639 sales@horizonhobby.Com united kingdom horizon hobby limited units 1-4 ployters rd staple tye harlow, essex cm18 7ns, united kingdom +44...

  • Page 21

    Flight log • fugbuch • journal de bord • volo log flight # date battery(s) flight time (m) (s) recharged (mah) comments example 6 0 11/12 1-3200mah 22.2v 6s 30c 2560mah cg at 150 mm.

  • Page 22

    ? 2013 horizon hobby, inc. E-flite, splendor, as3x, parkzone, blade, celectra, ec3, dsm, dsm2, dsmx, bind-n-fly and modelmatch are trademarks or registered trademarks of horizon hobby, inc. The spektrum trademark is used with permission of bachmann industries, inc. Apc and the apc logo are trademark...