E-FLITE Carbon-Z Splendor Instruction Manual - Troubleshooting Guide As3X
EN
Problem
Possible Cause
Solution
Oscillation
Flying over recommended
airspeed
Reduce air speed
Damaged propeller or
spinner
Replace propeller or spinner
Imbalanced propeller
Balance the propeller. For more information, view John Redman’s propeller balancing video at www.
horizonhobby.com
Flight condition variations
Adjust gain to current flight conditions (wind, updrafts, local conditions [elevation, humidity,
temperature, etc.])
Motor vibration
Replace parts or correctly align all parts and tighten fasteners as needed
Loose receiver
Align and secure receiver in fuselage
Loose aircraft controls
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Worn parts
Adjust gain to compensate for parts wear or replace worn parts (especially propeller, pivot points or
servo)
Irregular servo rotation
Replace servo
Incorrect transmitter type
(computerized or non-
computerized) assigned in
receiver
Assign correct transmitter type in the receiver (refer to receiver manual)
If oscillation persists...
Decrease gain (refer to receiver manual)
Trim change when
flight mode is
switched
Trim is not at neutral
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
Sub-Trim is not at neutral
No Sub-Trim is allowed. Adjust the servo arm or the clevis
Incorrect response
to the AS3X Control
Direction Test
Incorrect direction settings
in the receiver, which can
cause a crash
DO NOT fly. Correct the direction settings (refer to the receiver manual), then fly.
Channel 5 switch
position 0 is 3D and
position 1 is F3A
In your transmitter, Channel
5 servo is set to REVERSE
In your transmitter, set Channel 5 servo to NORMAL
Troubleshooting Guide AS3X
15