E-ZY EZ-GO Quick Install Manual - page 2
2
Qwik Install
STEP 1:
Choose a mounting location with good line of sight to the re-
mote location. The supplied bracket can be mounted to a wall or to an
existing pole up to 2” diameter. If only short distances are needed, the
antenna can be mounted inside a building.
TECH TIP: Microwaves travel in straight lines and they lose
strength quickly when going thru buildings and trees. If there are
objects in the microwave path, then useable distance will be reduced. If
the target unit is less than 1 mile away then you won’t have to worry too
DANGER! Avoid Powerlines!
You Can Be Killed!
When following the instructions in this guide to install the EZ2 take ex-
treme care to avoid contact with overhead power lines, lights and power
circuits. Contact with power lines, lights or power circuits may be fatal.
We recommend to install EZ2 no closer than 20 feet to any power lines.
Safety:
For your own protection, follow these safety rules.
▫
Perform as many functions as possible on the ground
▫
Do not attempt to install the antenna on a rainy, windy or
snowy day or if there is ice or snow accumulation at the install
site or if the site is wet.
▫
Make sure there are no people, pets, etc. below when you are
working on a roof or ladder.
▫
Watch out for any power lines which may be overhead, under-
ground or behind walls., keeping safely clear of them with the
antenna, ladders or any tools.
▫
See appendix for FCC RF exposure guidelines
Recommended Tools: Pliers , Screws and screwdriver if
mounting to a wall.
NOTE: You should be familiar with using
tools such as these before attempting installation of EZ-Go™.
You should be comfortable with working on a ladder.
GROUNDING: Local building and electrical codes require that
the antenna be properly grounded. Improper installation may
seriously damage the equipment or building, as well as cause in-
jury or death to you. Run a ground wire 10AWG or bigger from
mounting bracket of antenna to a good earth ground (Cold water
pipe or metal stake in ground).