E-ZY EZ-GO Quick Install Manual - page 3
3
much about a couple obstructions but if over 1 mile and there are some
obstructions in the microwave path, then the performance will be re-
duced.
STEP 2:
Mount the Bracket
To mount to a wall: The supplied u-bolt is
not used and the bracket is screwed directly
to a wall using customer supplied screws.
To mount to a pole: Use the supplied U-Bolt
and wing nuts. Make sure to use a lock
washer at each wing nut. Tighten wing nuts
evenly by hand. Use pliers if additional tight-
ness is needed.
STEP 3:
Mount the antenna housing to the
bracket. Put the hex head bolt thru the housing
back fin. Put the star lock washer so it is be-
tween plastic housing and metal bracket. Install
wing nut with lock washer. Adjust desired tilt an-
gle and tighten wing nut. Use pliers if additional
tightness is needed.
TECH TIP: Because of the specially designed wide beamwidth an-
tenna, pointing is not critical and simply pointing in the general di-
rection of the receiving antenna will yield great results.
STEP 4:
Remove the antenna bottom cover by using a coin
or house key or screwdriver to push in one of the side
snaps and then remove the cover.
STEP 5:
Route a CAT5 cable through the
bottom cover and plug into the RJ45 Jack
inside the unit. Keep the black gasket ma-
terial in the bottom of the cover to help
keep out dust and insects.
STEP 6: Route CAT5 cable from the EZ-
Go™ into the building. Always create a strain relief near
the antenna so the cable is not pulling directly on the an-
tenna. Use the CAT5 strain relief hook feature built into
the housing back fin. The Ethernet spec allows for a maxi-
mum cable length of 100 meters or about 328 feet.
STEP 7: Install the RJ45 connector on the POE Inserter to
the router, switch or computer. Attach the CAT5 cable from
the antenna to the RJ45 output port of the POE Inserter.