E2v UNIIQA User Manual - page 21
U
SER
M
ANUAL
UNIIQA+
C
OLOR
–
R
EV
I
–
09/2016
P
A G E
|
21
Serial Number (
DeviceID
) : Camera serial Number set by in factory in a 64Bytes String.
Read function (ASCII): “r deid”;
Returned by the camera : Serial Number of the camera in a String of 64 bytes (including “/0”)
Can’t be written
Device User ID (
UserDefinedName
) : Camera identifier set by the User in a 64Bytes String.
Read function (ASCII): “r cust”;
Returned by the camera : String of 64 bytes (including “/0”)
Write function (ASCII): “w cust
7.2 Device Privilege, Standby, Status and Reboot
Privilege level Management (
PrivilegeLevel
) : Get the current Camera privilege level.
Read function (ASCII): “r lock” : Get the current privilege
Returned by the camera : 0 to 2
Write function (ASCII): “w lock
2 : Lock the Camera in Integrator or “privilege User”
GenCP address
ASCII
command
GenICam
command
Size R/W Description
0x17040
lock
PrivilegeLevel
4
RW Read:
0 : Factory
1 : Advance User
2 : User
Write :
1 : change mode from factory to
AdvanceUser
2 : change mode to User
Other: key to unlock the camera
0x17048
stat
Status
4
RO
Camera Status; bit set when :
Bit0 :no trigger during more than 1s
Bit1 : trigger too fast
Bit2 : reserved
Bit8 : overflow occurs during FFC calibration
Bit9 : underflow occurs during FFC calibration
Bit16 : hardware error detected
0x17050
boid
BoardID
32
R
Unique Board Identification. Written by the
camera manufacturer or test bench
0x17070
bost
BoardStatus
16
R
Give the status of the board. Written by the
camera manufacturer or the test bench
0x17080
boot
RebootCamera
4
WO
Reboot the camera with a command
1 restart the camera (like a power cycle)
2 restart only camera application (bypass
upgrade application)