E2v UNIIQA User Manual - page 34
U
SER
M
ANUAL
UNIIQA+
C
OLOR
–
R
EV
I
–
09/2016
P
A G E
|
34
Digital Green
Blue
Gain (
Gain
with
GainSelector
=
DigitalGreenB
) : Set the Green
Blue
Gain for the white
balance. This command is available in the CommCam “Color Management” section :
Read function : “r gwbj”;
Returned by the camera : Integer value from 0 to 1548. The corresponding Gain is
calculated as 20.log( 1 +
Write function : “w gwbj”
White Balance Enable Switch (
WhiteBalanceEnable
) : Enables the White Balance Gains. This
command is available in the CommCam “Color Management” section :
Read function : “r gwbe”;
Returns the White Balance Gain Enable Status.
Write function : “w gwbe
0 : Disables the White Balance Gains
1 : Enables the White Balance Gains
White Balance Calibration Control (
AutoWhiteBalanceStart
) : Launch or abort of the White Balance
process for the RGB Gains calculation. This command is available in the CommCam “Color
Management” section :
No Read Function
Write function :
“w awbc 1” : Launch the White Balance Calibration Process.
“w awbc 0” : Abort the White Balance Calibration Process.
Interpolation Corrections for True Color Modes
Column Interpolation Enable Switch (
ColumnInterpolation
) : Enables the Column Interpolation.
This command is available in the CommCam “Color Management” section :
Read function : “r ccit”;
Returns the Colum Interpolation Enable Status.
Write function : “w ccit
0 : Disables the Colum Interpolation
1 : Enables the Colum Interpolation
Line Interpolation Enable Switch (
ColumnInterpolation
) : Enables the Line Interpolation. This
command is available in the CommCam “Color Management” section :
Read function : “r clit”;
Returns the Line Interpolation Enable Status.
Write function : “w clit
0 : Disables the Line Interpolation
1 : Enables the Line Interpolation
Colum and Line Interpolation.
Please, refer to
chapter §2.2
for a detailed explanation of these two interpolations available for
the User.