Eagle CLAGGH Series Installation & Operating Instructions Manual - page 5
UNITS ThAT hAVE MANUAL VALVES wITh STANDING PILOTS OR
ThERMOSTATIC CONTROLS wITh STANDING PILOTS
Lighting and Shutdown Instructions:
Turn pilot valves on and light pilot
burners using a lighting wand or taper.
Before using this appliance, the pilots
must be adjusted. Do this by turning the
control adjustment screw in one pilot,
adjust the valve, and use the lighting wand
to light that pilot burner. Adjust the size of
the pilot flame. Repeat for each pilot valve.
When lighting the burners by turning on
the burner knobs, always make sure the
burner has lit properly from the pilot by
looking through the observation port.
When shutting the appliance down for
long periods of time, shut off all the burners valves; then shut off all the pilot valves.
CAUTION: Before attempting to light the appliance, the cover, if so equipped, shall be
opened. If pilot or burners go out, turn off all gas and wait 5 (five) full minutes before
attempting to relight.
4
Propane Gas Conversion:
This griddle is shipped from the factory with fixed Orifice Hoods for use on Natural Gas. To
convert to Propane Gas, install the burner Orifice Hoods supplied (located in the grease drawer).
1) Pull the Control Panel forward from the top and allow it to drop down. On models where
control panel is attached with screws, remove screws then remove control panel.
2) Remove the Access Panels.
3) Remove burner(s) from the Orifice Hood(s) by sliding the burner toward the rear and lifting
off the hood(s).
4) Remove #41 Natural Gas Orifice Hood(s) and install the #52 Propane Gas Orifice Hood(s)
marked in red.
5) Reinstall the burner(s).
6) Reinstall the Access Panels.
7) Change the convertible pressure regulator to Propane Gas by removing slotted or hex
threaded plug from pressure regulator, invert and reinstall. The letters LP should be visible.
The regulator is now set for 10˝ W.C.
8) Adjust the Standing Pilot(s) flame height for Propane by turning the screw located on the
pilot valve body.
9) Reinstall Front Panel.
INSTALLATION INSTRUCTIONS (continued)