Eaglemaster E5 G7 User manual - page 12
Check-in range notification (on/off )
Arming the system within 2 seconds, press button
once on the 2way remote , the
system will enable this Check- in range function.
- With in 5 minutes, the 2-way remote will than give 1 beep sound every one minute for 5
cycles to remind the user within range.
- After 5 minutes, the 2-way remote will detect range every 10 minutes and without any beep
sound, the icon
will constant on if the user within range.
For friendly usage, the 2-way remote will provide 2 beeps/ 3cycles and flashing icon
if the user is out of the receiving rage. However, afterwards if the 2-way remote detect the
signal again from the system, the icon
will be ON to indicate the 2-way remote is within
range.
Note: If under Check-in range mode, if alarm triggered, this function will automatically
turn off (disable).
The 2way remote
will respond:
This Icon will turn on and give 1 beep
sound to indicate the function has been
turned ON.
Time adjust mode
Besides operating for alarm functions, LCD remote control additionally provides 24-hour
real time clock.
Instructions:
1. Press and hold Button
for 2sec. to enter time-setup mode, 1 beep will be heard.
2. Press button
to select Hour & Min adjust setting. Icon flashing to indicate.
3. Press button
to turn up the numbers. Press button
to turn down the numbers.
The button may be held down to scroll faster.
4. Press button
to exit the setting mode. 2 beep will be heard.
Note: The remote will revert to normal operation from the set mode when 10-seconds has
elapsed without a button entry.
Minutes display
24-hour display