Eaglemaster E5 G7 User manual - page 25
- Turbo mode:
If programmed with the feature , this channel will constant output when ignition turn on for
over 1 minutes. It will keeps the engine running after arriving at your destination by ignition
off , the turbo will turn on and give a warning beep. This turbo time can be programme time
for 1, 3, 5, or 10 minutes. This allows the system's timer to conveniently cool down the
turbo after you have left the vehicle.
Exit: You may disable this turbo mode at anytime, simply press button
once, the
turbo mode will stop immediately.
Note: in turbo mode time , if arming the system, sensors will be bypassed and Lights
flashing for a programmed turbo time.
- CH-6 (-) programme time output:
This channel-5 is a negative (-500mA) output features, this channel can be programmed
(1)- Arming output from 1~120sec.
(2)- Press button
, output from 1~120sec.
(1)- Arming output 1~120sec. if programmed, this channel will activate when arming, the
output timing can be programmed from 1 to 120seconds.
(2)- Press button
output 1~120sec. If programmed, to operate this channel by press
button
for over 2sec. This channel will constant output for programme time.
Exit: When this channel is outputting, if press button
once, it will stop outputting.
NOTE: This channel can be programmed pulse delay time (1~120sec.), If programmed,
channel-5 will delay output with programme pulse delay time.
2-way LCD display
:
Flash icon
Turn on icon
Run time icon will turn on 2sec. for programmed
time of (
,
,
,
). and then it will display every
2sec. of
alternate run-time and
current-time.
Note: if turbo time's
up , the icon will display
, and
give a warning beep .