Eaglemaster E5 G7 User manual - page 18
- Disar m without siren chir p :
To disarm your system without siren chirp , simply press and hold the button
for over
2sec.
Note: this features is only activated under the system is in armed position,.
- Silent ar m mode :
The system provide a feature to turn OFF the siren, simply press 2-way button
of press(while system in disarmed or Acc off position) . The system will respond one lights
flash, doors lock, disable engine starter, LED will begin flashing quickly until all sensor
inputs are active - LED will start blinking slowly (flash once per second) to indicate the
system is full armed.
Note: Under Silent Arm mode, if Sensor, Door, Hood or trunk been triggered, the siren will
not activated, but if Ignition been triggered will activated the siren.
- Automatic REARM (programmable):
If the system is disarmed by remote and a door is not opened within approximately 30
seconds the system will automatically rearm itself. This feature guards against disarming
caused by accidental or unintended operation of the remote transmitter. Main unit will
sends signal to the 2-Way LCD remote and indicates ARM mode with one beep sound.
- Passive ar m (programmable):
If set programme mode to "WITH", while turn Ignition OFF, then close the last door ,system
will provide 2 siren chirp and 2 light flash and LED flashing fast to indicated that the system
is in passive arming mode. After 30sec. The system will arm by itself and LED flashing slowly
to show the system is in arming mode. Main unit sends the signal to the 2-Way LCD remote
and indicates ARM mode with one beep sound .
This system also provide under passive arming with door lock or without door lock
feature (please see "programme mode" features. ) During the period of 30sec. passive
arming, if a door is opened, Led will light on and it will re-passive arming when the door
closed again.
2-way LCD display
:
+ One beep sound
2-way LCD display
:
Flashing icon to indicate
that the system is in Auto
re-arming mode.
Icon flashing
indicator
2-way LCD display
:
Icon flashing
indicator
Two beep sound will provided
to
to indicate that the system is in
Passive arm mode.