Earlex SPRAY PORT HV 7000 Operating Instructions Manual - page 11
11
The paint drips
Paint too diluted
Add undiluted material
on item
Paint volume
Reduce the paint flow
being painted
too high
by turning Fluid Adjusting Screw
Moving too slowly
Increase speed of application
Spray gun trigger being
Release trigger earlier
held for too long
Spray gun too close
Increase the distance between
gun and workpiece
Paint is thin or
Paint too diluted
Add undiluted material
irregular
Paint volume
Increase the paint flow by turning
too low Fluid Adjusting Screw
Moving too fast
Reduce speed of application
Spray gun clogged Clean the gun
Spray gun too far away
Reduce the distance between
gun and work piece
No spray pattern Paint too thick Add thinner
being produced Gun clogged Clean the spray gun
Pick up pipe clogged Clean Paint Feed Tube
Air hose split
Replace air hose
Gritty paint
Filter the paint
Container almost
Refill container
empty
Spray gun at an angle
Ensure Paint Feed Tube
is angled towards paint
Air intake
Check the condition of
blocked
the Filter and clean as neccessary
Unit will not
Circuit breaker tripped
Check the back of the unit. If the circuit
start
(HV7000 unit) breaker has tripped, a white push button
indicator will appear. Push in to reset.
If this does not cure the problem, please
refer to your nearest service agent.
House circuit breaker
Check and reset if required.
PROBLEM CAUSE
ACTION REQUIRED
TROUBLE SHOOTING
N0151 07_05.qxd 16/01/2006 10:49 Page 11