Earlex SPRAY PORT HV 7000 Operating Instructions Manual - page 12
12
Earlex Ltd, Earlex House, Moorfield Road, Guildford, Surrey, GU1 1RU
Customer Service: +44 (0) 1483 454666
E.mail: enquiries@earlex.co.uk Website: www.earlex.co.uk
Copyright & Design Right Reserved © 2005
Design Registration UK 3015591
© 2006 Earlex Products. N0151 01/06
GUARANTEE
This product is guaranteed for a period of 12 months for ordinary use and 6 months for hire purposes or
where the unit is lent to other users.The guarantee is against faulty manufacture and materials. Whilst
every possible care is taken by Earlex to ensure that our products leave the factory in good working
order, Earlex cannot under any circumstances accept liability for problems or damage caused by their
subsequent use. It is the responsibility of the user to ensure that surfaces to be treated or cleaned are
suitable for spraying. The guarantee does not affect your statutory rights.
MAINS CONNECTION 230V UK ONLY
The Spray Port is supplied fitted with a 13 amp plug top and fuse. If a replacement fuse is required
this must be rated at 13 amps. If in doubt consult an electrician.
WARNING - THIS APPLIANCE MUST BE EARTHED.
If any eletrical component is damaged or faulty, it must be replaced by the
manufacturer or it’s appointed service agent or a similarly qualified person in order to avoid a
hazard.
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
z
The wire which is coloured green and yellow must be connected to the terminal in the plug
which is marked with the letter E or by the earth symbol, or coloured green or green and yellow.
z
The wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black.
z
The wire which is coloured brown must be connected to the terminal which is marked with the
letter L or coloured red.
MAINS CONNECTION 110V UK ONLY
The stripper is fitted with a 16 amp industrial plug for insertion into a suitable transformer or
generator supplying 110V a.c. outlet. If this mains cable becomes damaged it must be replaced by
the manufacturer or it’s appointed service agent or a similarly qualified person in order to avoid a
hazard.
N0151 07_05.qxd 16/01/2006 10:49 Page 12