East EA610 User manual - page 13
-22-
2. In setting mode, after confirming the selected parameters, press the key “
”
momentarily to save the interface. Press the key “
” or “
” momentarily,
choose “Yes”, and then press the key “
” momentarily to save and exit it.
Direct-exit setting
1. Press the key combination “
” for 5 seconds in the setting interface
to restore factory settings of UPS, and then exit the setting interface.
2. Press the key “
” for 3 seconds to exit the setting interface of UPS without
saving the data.
6. Parameter Query Operation
Press the query key “
” or “
” momentarily to check output, load, temperature,
input and battery information in turn.
In non-setting mode, press the key “
” for 2 seconds to enter the state of
automatic page up/down and re-press the key for 2 seconds to exit the state of
automatic page up/down.
1. Output Display UPS output voltage and output frequency, as shown below (the
left figure shows the display interface of rack UPS, and the right figure shows
the display interface of tower UPS).
2. Load Display WATT and VA values of the connected load, depending on load
type and load value, as shown below (the left figure shows the display interface
of rack UPS, and the right figure shows the display interface of tower UPS).
-23-
3. Temperature Display the temperature inside the chassis, as shown below (the
left figure shows the display interface of rack UPS, and the right figure shows
the display interface of tower UPS).
4. Input Display the input voltage and input frequency, as shown below (the left
figure shows the display interface of rack UPS, and the right figure shows the
display interface of tower UPS).
5. Battery Display the battery voltage and battery capacity, as shown below.