Eastern Tools & Equipment Liquid Propane Operation Manual - Safety
Warning

Other manuals for Liquid Propane: Operation manual, Operation Manual
Manual is about: 7000 Surge Watts 6000 Continuous Watts

Summary of Liquid Propane

  • Page 1

    1 eastern tools & equipment, inc liquid propane portable generator operation manual 7000 surge watts 6000 continuous watts customer service(888)‐908‐6200 www.Easterntools.Com eastern tools & equipment. Inc ontario, ca u.S.A.

  • Page 2: Table
Of
Contents

    2 thank you for purchasing products from easterntools & equipment, inc. We appreciate your business. The following manual is only a guide to assist you and is not a complete or comprehensive manual of all aspects of maintaining and repairing your generator. The equipment you have purchased is a comp...

  • Page 3: Safety
Warning

    3 safety warning please read this manual to understand how to use your unit as well as understanding the risk the come with the unit. Notice exceeding your generator wattage/ amperage coverage capacity can damage your unit as well as any devices attached to your unit. Consumers should notice that th...

  • Page 4

    4 keep the same concept when disconnecting electrical devices; make sure all devices are in the "off" position before disconnecting. Operate the generator on level surfaces only. Inclined surfaces reduce the effective lubrication of the engine. Do not expose the generator to excessive moisture, dust...

  • Page 5

    5 controls and features read this owner’s manual before operating your generator. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference. No. Description qty no. Description qty 1 ac circuit breaker 20a 1 11 oil indicator light assy 1 ...

  • Page 6: Out

    6 operation instruction of reductor assembly instruction on lpg denser device (bottom) to develop cold start performance of lpg generator unit, the air reductor assy includes one lpg denser device (bottom), the detailed operation of the bottom is shown below. When starting the cold lpg generator uni...

  • Page 7

    7 handle and wheel kit assembly the wheel kit mist be assembled when there are no liquids in the generator. 1. Place the generator on its side. (engine side down). 2. Secure the axle with two u bolts. 3. Screw on the nuts onto the u‐bolts to secure the axle. 4. Place the washer onto the axle. Place ...

  • Page 8: Battery Assembly

    8 battery assembly procedure step 1 step 2 step 3 step 4 step 5 step 6 ok (+) ( - ) bolt +nut bolt bolt (+) (-).

  • Page 9

    9 starting the unit make certain the generator is on a flat, level surface. 2. Disconnect all electrical loads from the generator. Never start or stop the generator with electrical devices plugged in or turned on. Disconnect electrical devices 3. Connect lpg tube to the lpg tank, and then open the l...

  • Page 10

    10 maintenance generator maintenance consists of keeping the unit clean and dry. Be sure to store the unit in a clean and dry environment, where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling slots should always be clean and free from clogs. Note: do not us...

  • Page 11

    11 trouble shooting problem cause solution no propane new tank faulty spark plug replace spark plug generator will not start unit loaded during start up remove load from unit low oil level fill crankcase to the proper level place generator on a flat, level surface choke in the wrong position. Adjust...

  • Page 12

    12 wiring diagram.

  • Page 13

    13 parts list number part number description qty 1 e0001-190-00-lpg engine assy (lpg) 1 2 33100-pg60-00 control panel assy 1 3 94101-06000-00 washer,plain 6mm 4 4 33710-l90-00 connect valve assy 1 5 50310-pg60-00 frame comp 1 6 82350-t80-00 immobility board 1 7 77330-188-00 bottom rubber b 2 8 94050...

  • Page 14

    14 20 16520-t80-00-pt369c tank comp,fuel(green) 1 21 95701-06016-00 bolt,flange m6x16 2 22 53136-t80-01 immobility piece(rubber) 2 23 95701-06012-00 bolt,flange 6 12 9 24 18350-tg50-00 muffler comp 1 25 18323-188-00 latex (protr,in muffler) 1 26 18382-188-00 muffler stay 1 27 18381-188-00 gasket,muf...

  • Page 15

    15 about your product warranty eastern tools & equipment, inc. Welcomes warranty repair and apologizes to you for being inconvenienced. Any authorized service dealer may perform warranty repairs. Most warranty repairs are handled routinely, but sometimes warranty service may be inappropriate. For ex...

  • Page 16

    16 warranty is available only through service dealers, which have been authorized by eastern tools & equipment, inc., please contact the place of purchase or eastern tools & equipment, inc. For a service dealer near you. California & usepa emission control warranty statement the u.S. Environmental p...

  • Page 17

    17 product registration for more efficient customer service, please fill out the information below and mail to eastern tools & equipment, inc. Product warranty and registration division. Model no._________________ engine serial no.____________ purchase date ____/____/_____ purchased from: [ ] retail...