Eastman Outdoors 37211 Instruction And Safety Manual - Step 2.1 Lighting
OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Page 10 of 18
turn gas OFF at the LP tank. Spiders and other insects can build nests inside the burner venturi
blocking air and gas flow. If this occurs, with gas OFF at LP tank and burner cooled to room
temperature, remove air shutter, spring, and hose assembly and clean venturi tube and casting
holes with a bent wire, heavy-duty pipe cleaner, or screwdriver through the air shutter holes.
Compressed air may help clear away smaller particles. If burner casting is not cleared, flush water
or use compressed air through the small casting holes to blow or wash out debris through the air
shutter holes. Once cleared, reassemble air shutter, spring, and hose assembly. If flame occurs
inside venturi tube, this is caused by a blockage and may cause damage to hose/orifice assembly.
Step 2.1 Lighting
Locate the appliance outdoors in well-ventilated areas, clear of combustible materials, and on a level, stable,
noncombustible surface like brick, concrete, or dirt.
If there is wind, locate the appliance in an outdoor area that is protected from the wind.
Close regulator control valve by turning valve clockwise until tight. Start propane gas flow from LP tank
by slowly turning the LP valve two complete turns counter-clockwise.
Place a lit match (Eastman Outdoors strongly
recommends using a long-stem match or lighter)
under the burner up through the hole in the center
of the burner element (figure 27).
Fig. 27
Slowly turn the regulator control valve a half rotation (counter-clockwise) until burner lights. Do not open
regulator control valve more than 1/2 a turn until the burner is lit.
If burner does not ignite in 3 to 5 seconds, turn regulator control valve off and turn LP tank valve off.
Check to make sure the LP tank is not empty. Wait five minutes for gas fumes to dissipate.
Do not
attempt to re-light if you smell gas. Disconnect the QCC1 fitting and reconnect it to LP tank. Doing this
Always locate LP tank a minimum of 3ft (0.9m) upwind from burner. (figure 26)
MAINTAIN A DISTANCE
OF 3 FT (0.9M) BETWEEN
LP TANK & BURNER
WIND
DIRECTION
LP TANK
Fig.26
Trip hazard. Do not step over/walk between LP tank and hose.
Do not use on porches, wooden decks, picnic tables or in a building, garage,
under overhangs, or any enclosed area.
Do not use on any surface that will burn or melt like wood, asphalt (blacktop),
vinyl, plastic or on a soft surface.
Failure to follow these instructions can lead to fire or explosion, which could
cause property damage, serious personal injury or death.
Do not allow your hands, hair, fabric, clothing, or any body part to be over
appliance or on appliance when lighting.
Failure to follow these instructions can lead to serious personal injury or
death.
•
Always have a Type BC or ABC dry chemical fire extinguisher readily available.