Eastman Outdoors 37211 Instruction And Safety Manual - page 6
OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Page 6 of 18
Place the shutter spring (8) onto burner
orifice/regulator hose assembly (5) by sliding the
small end of the shutter spring onto the burner
orifice/regulator hose assembly (figure 7).
Fig. 7
Set the air shutter (#7) onto the burner element (#3)
by placing it on the casting (figure 8).
Fig. 8
IMPORTANT: Line up hose/orifice assembly (#5) with the hole in the burner element (#3) so the orifice is
perpendicular to the burner element (figure 9). Finger-tighten orifice into the hole and then wrench tighten
with an adjustable wrench 1 to 2 revolutions or until snug (figure 10).
DO NOT OVER TIGHTEN. The
connection is tight enough when one cannot loosen the hose/orifice by hand. Proper connection is
critical for correct operation of the burner.
Fig. 9
Fig. 10
Step 1.3 Leg Adjustment
To extend legs, loosen lower locking knob on leg
(figure 11).
Fig. 11
Push in the snap button on the top inside of the leg
(figure 12). (When shortening legs, push in the
snap button next to the lower locking knob on each
leg.).
Fig. 12
Extend leg until the lower snap button snaps into
place by the lower locking knob. Retighten lower
locking knob (figure 13).
Fig. 13
Step 1.4 Fuel Safety
Only use LP gas with this appliance.
Only use an approved 20 lb. LP gas tank with this appliance (the same as those commonly used on gas grill
Only use HIGH leg position with low profile cooking vessels
smaller than 12 quarts and woks 18 inches or smaller.
Failure to follow these instructions can lead to fire or
explosion, which could cause property damage, serious
personal injury or death.