Eaton i-on16 Installation Manual - Appendix I. Recording
i-on16
Page 24
Appendix I. Recording
Speech Messages
To record the speech messages you wish the i-
sd01 speech dialler to use enter Installer mode and
select Reporting – Speech Dialler – Messages.
There are five messages slots available: The Home
Message and Messages 1 to 4. Within each
message you can use one of the following options:
Record Message Press to start recording. The
control unit starts recording from the built in
microphone. The display shows a progress bar
indicating how long you have left to record. Press
to end recording.
Play Message
Press to play back the message.
Delete Message Press to delete the message.
When the display asks “Delete Message?” press .
Use Lid Tamper This puts the control unit into a
special mode where the tamper switch controls the
recording and playback of the current message.
Use this mode if the end station is an inconvenient
distance from the keypad.
1. Start with the end station lid off and the tamper
switch open.
2. At the keypad select Use Lid Tamper and press
.
3. At the end station hold down the tamper switch.
When the red LED on the I-SD01 glows recite
your message.
4. Release the tamper switch.
5. Pulse the tamper switch briefly.
The I-SD01 plays back your recording.
6. Go back to the keypad and press .
7. If required, replace the end station lid. DO NOT
replace the end station lid until you have left the
“Use Lid Tamper” mode.
www.coopersecurity.co.uk
Product Support (UK) Tel: +44 (0) 1594 541978.
Available between:
08:30 to 17:00 Monday to Friday.
Product Support Fax: (01594) 545401
email: techsupport@coopersecurity.co.uk
Part Number 12309432
6/1/2014