Eaton Powerware 9140 Installation Manual - Ebm Setup

INSTALLATION

Eaton

®

 9140 (9910-E82/E83) UPS Installation Guide for IBM

®

 Applications  

S

  164201715 Rev 2

www.eaton.com/ibm

6

EBM Setup

The E82/E83 EBM comes with all hardware required for installation in a

standard EIA or JIS seismic rack-mount configuration with square or

round mounting holes. The rail assemblies adjust to mount in 48-cm

(19-inch) panel racks from 61 to 84 cm (24 to 33 inches) deep [72 to

81 cm (28.5 to 32 inches) deep if installing the optional seismic

mounting brackets].

Checking the EBM Accessory Kit

If you purchased an optional EBM, verify that the following items are

included with the EBM (PN 44V3921):

NOTE  

If the EBM is factory-installed in an IBM rack, these items are pre-assembled.

S

Mounting brackets and fasteners (if not already installed):

-

(2) front mounting brackets

-

(2) rear mounting brackets

-

(12) M4 flat-head screws, plus (2) extra

S

Rails and fasteners:

-

(2) sliding rail assemblies (left and right)

-

(4) adapter plates (for 7.1 mm round hole)

-

(4) adapter plates (for 9.5 mm square hole)

-

(16) M5 machine screws, plus (2) extra

-

(2) M6 machine screws, plus (2) extra

-

(2) M6 clip nuts for racks with round holes, plus (2) extra

-

(2) M6 cage nuts for racks with square holes, plus (2) extra

-

(8) M4 machine screws with (8) M4 locknuts, plus (2) extra of each

S

Optional seismic mounting brackets and fasteners:

-

(2) EBM seismic mounting brackets

-

(4) wing bolts, plus (1) extra

-

(4) M6 machine screws

S

EBM user's guide (located in the carton labeled 9910-6646 Acc Kit,

PN 44V3922)

NOTE  

Discard the EBM user's guide if you are installing the EBM with a new UPS at the

same time. Use the UPS user's guide instead to install both the UPS and the EBM.