Eberspracher EasyStart R+ Operating Instructions Manual - page 6
6
Operation and Adjustment
Basic operation and adjustment rules
Activate mobile unit
Before each operation or setting, a con-
nection must be established between the
mobile unit and the stationary unit.
To do this, press until the LED display
is permanently lit green, then release the
key and continue with the operation or
adjustment (see also page 7).
Switch off mobile unit /
protect against involuntary actuation
If is pressed for a long time the LED
display disappears, i.e. the mobile unit is
switched off and is therefore also protec-
ted against involuntary actuation.
Confirm input
The settings and changes must always
be confirmed with , otherwise they
are lost.
Permanently set operating time
The operating time can be set in 4 steps
(20, 30, 40 and 60 minutes).
See page 10 for description.
LED display disappears
After confirming a setting or change the
LED display disappears after 10 seconds,
i.e. the mobile unit switches to its normal
condition.
If a setting / adjustment or confirmation
is not made within 10 seconds the LED
display disappears, i.e. the mobile unit
returns to its normal condition.
For renewed input you must press
again.
If data transmission was not possible, the
LED display disappears after 4 seconds.
Display during data transmission
During data transmission the LED display
is permanently lit green.
Terminate/quit settings
The setting can be cancelled or termina-
ted with .