Ebpromotion mystere mws User Manual - page 3
Bedienungs-Anleitung Mystère Januar 2002
eb
PROmotion, Cité Robinson10 2074 Marin, Schweiz
www.ebpromotion.ch
2
Tel +41(0)32 763 05 63 Fax +41 (0)32 763 05 64 e-mail: erich@ebpromotion
Front panel
1. 4 Control knobs for channel - level
Switches on the control-panel allow to link electronically channel 1 and 2 as well as
channel 3 and 4. This allows a one-knob control of two channels.
2. 2 Control knobs (red) for the output - level
Both output channels can be linked for one – knob control by a switch on the control-
panel. It is possible to bypass these controls by selecting "CAL" on the switch aside the
knobs for a calibrated output at +6dBu.
3. 4 Gain - control knobs for microphone and line input
When Setting the gain control it is important to observe the overload indicators. Increase
the gain until the LED lights up, then reduce it till the LED turns out. Hoe much you have
to reduce the gain depends on the level of the signal you will have to amplify. Be aware
that a distortion on the input amplification can not be corrected by the output-limiter.
4. „LEVEL“
Level control for the headphone
5. Monitoring switch
Select Stereo, Mono, Left, Right or MS (for the headphone out put only)
6. „BATT“
Push-button for battery-level-control. While pressing the button, the upper row of LED
indicates the charging status of the battery. With fully charged battery all LEDs
illuminate. Every diode less signifies a drop of 0,2V battery tension. The 0 on the scale
above the display corresponds to nominal battery tension providing the setting of the
mixer has been done correctly. (See page 10)
When using a V-mount (or similar) adapter for lock-on batteries with information about
remaining capacity, the mixer can use this information for its display. (e.g. IDX Endura)
7
12
1
2
10
11
3
6
9
5
8
4