Eccotemp CEI-12 Use & Care Manual - Use and Starting
9
Product Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
1. Turn on incoming water supply. Ensure that you have adequate water pressure
of 0.25-10 (p
w
)(bar).
2. Turn your water output device to its “off” position.
3. Check and verify gas is turned on and there are no leaks.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE GAS VALVE IMMEDIATELY!!
5. Set the water regulator knob on the face of the unit to its highest setting.
6. Set the gas regulator knob on the face of the unit to its minimum setting.
7. Turn on your water output device to the “on” position and adjust to the desired
water flow.
8. There will be a series of audible clicks and the burner will ignite. (Should
the burner not ignite after 5 seconds, shut off and go to the “Trouble Shooting”
section.
9. Upon completion of use or storage, open the drain valve (ribbed cylindrical
stem next to the water input valve) to ensure draining of water.
10. Turn off your gas supply.
11. WARNING: If the outside temperature is around or below freezing (32 degrees
F, 0 degrees C), ensure that the drain valve is opened and water drained from
the unit after each use to avoid internal damage to the water regulator. You will
also need to unhook the outgoing water line to ensure that any water in the heat
exchanger is drained. Failure to properly drain your unit will cause water damage
which may or may not be reparable. Please check the warranty information
found on our website at www.eccotemp.com/freeze for more information on
freezing issues.