Echola SPDU-108M Installation Manual - page 7
Echola Systems L.L.C
1161 Ringwood Ct, Ste 100
San Jose, CA-95131
Phone: 408 321 9663
http://www.echola.com/power
Initial Software Configuration
You may need to change network settings of Echola PDU device before connecting it to
your network's switch/router. If your network has a DHCP server then you may want to
skip this section and connect PDU Ethernet port to their network's switch/router and the
IP address will be assigned automatically by your DHCP server. The assigned IP address
will be shown on the LCD panel. Use that IP to login into PDU and manage it.
If you don't have a DHCP server running on your network then you may want to configure
Static IP; there are three ways you could do this:
1.
Using NBNS (NetBIOS Name Service) of PDU
2.
Using built-in DHCP server of PDU
3.
Using Static IP configuration of your PC/Laptop
Using NBNS (NetBIOS Name Service)
Using NBNS (NetBIOS Name Service)
Using NBNS (NetBIOS Name Service)
Using NBNS (NetBIOS Name Service)
You would need a Windows based Laptop or a PC to configure PDU using this method for
the first time. You may also need a ethernet crossover cable to connect PDU to a PC or a
Laptop but most of the modern PC/Laptops would work with either type of cable (straight
or crossover). Make sure the PC/Laptop IP option "Obtain IP address automatically" is
checked in the Internet Protcol Properties of the ethernet interface. Now launch the
internet browser and type
http://echolasys
in the address bar and press Enter key. Now
you will be prompted with a PDU's login dialog; If this is first time then use default
username and password. After login, you will see the main menu page of the PDU. Now
click on the Setup tab of the menu to bring the Network Config menu. From here you can
assign static IP, subnet mask and gateway and save your configuration. Thats it, now you
are set to connect PDU to your network/switch/router and access it from remote.
•
Default Username
Default Username
Default Username
Default Username: admin
•
Default Password
Default Password
Default Password
Default Password: admin
Using built
Using built
Using built
Using built----in DHCP server
in DHCP server
in DHCP server
in DHCP server
The procedure is same as above NBNS except that instead of using hostname 'echolasys' in
your browser you will have to use the IP address (like
http://192.168.2.222
) displayed on
the LCD panel. This method works for non-windows PC/Laptop as well.
Using Static IP configuration
Using Static IP configuration
Using Static IP configuration
Using Static IP configuration
Configure your PC/Laptop ethernet port's IP address to match the network portion of
default IP adress of PDU.
•
Default IP Address of
Default IP Address of
Default IP Address of
Default IP Address of PDU
PDU
PDU
PDU: 192.168.2.222
•
Default Gateway of
Default Gateway of
Default Gateway of
Default Gateway of PDU
PDU
PDU
PDU: 192.168.2.222