Echola SPDU-108M Installation Manual - page 8
Echola Systems L.L.C
1161 Ringwood Ct, Ste 100
San Jose, CA-95131
Phone: 408 321 9663
http://www.echola.com/power
•
Default Subnet mask of
Default Subnet mask of
Default Subnet mask of
Default Subnet mask of PDU
PDU
PDU
PDU: 255.255.255.0
For example you can configure your PC/Laptops IP address as 192.168.2.222 and access
the main menu of PDU. After configuring the PC/Laptop ethernet address, just use any
internet browser to access PDU with new configure IP address. Now you will be prompted
with PDU's login dialog; If this is first time then use default username and password. Now
the default network settings of IP, subnet mask and gateway can be changed to match your
network setting through
Setup
tab.
•
Default Username
Default Username
Default Username
Default Username: admin
•
Default Password
Default Password
Default Password
Default Password: admin
User Authentication
User Authentication
User Authentication
User Authentication
Admin user is always the previlaged user who can access any web page. You can also create
a different user who can access to main Control/Monitor page but is not allowed to access
Setup
page. This user is by default called "guest" but name can be changed using
Setup-
>User
tab and default password is "guest" as well.
If the authentication fails "Authentication Required" message will be displayed. The
authentication can optionally be disabled for Control/Monitor web page (the home page)
on the main menu by using
Setup->User
setting so that admin or guest user can access
main page without login but the
Setup
web page will still require login.
User Interfaces
User Interfaces
User Interfaces
User Interfaces
Front Panel LCD
Front Panel LCD
Front Panel LCD
Front Panel LCD
LCD moving character display on the front panel displays following important information.
This is useful when you are near the device to setup or monitor.
1.
Hostname
2.
IP Address
3.
Outlet Status
4.
Total Current Consumption in Amps
The outlet status shows the status of all 8 outlets and it could be one of the following,
(1) o (Empty circle): means corresponding outlet is switched OFF
(2) ● (Filled circle): means corresponding outlet is switched ON
(3) x (Cross): means corresponding outlet has been shut off due to overload
(Individual port overload protection feature)