Eco Range ECOFLAM MAX Instructions For Use Installation And Servicing

Manual is about: 3 oven oil fired Cooker

Summary of ECOFLAM MAX

  • Page 1

    Eco range 3 oven oil fired cooker for use in great britain and eire (gb & ie) instructions for use, installation and servicing this appliance must be installed in accordance with the regulations in force and only used in an adequately ventilated space. Please read these instructions before installat...

  • Page 2

    1. Introduction thank you for choosing to purchase the 3 oven oil, balanced flue or conventional flued, eco range cooker. Each cooker is manufactured and assembled by hand in our factory. This appliance is designed to be capable of operating for long periods of time. With correct installation and us...

  • Page 3

    This appliance is very heavy and every care should be taken when trying to manoeuvre it. Do not attempt to move or lift the appliance by the door handles, this could cause damage to the doors and handles. It must be sited on a solid, level floor constructed in accordance with any building regulation...

  • Page 4

    Safety notices and regulations the building regulations – part j england and wales – part f section iii scotland – part l northern ireland – part j ireland. Bs5440 parts 1 and 2 installation of flues and ventilation. D.M.2. Installation of timber framed buildings. Safety document 635 the electricity...

  • Page 5

    Ovens 3 of each – height 270mm depth 500mm width 345mm your cooker is fitted with a thermostatic control device. This operating system provides the exact heat requirements selected (by the user) for cooking and reduces the overall oil consumption. The user selects the desired cooking temperature and...

  • Page 6

    4.4 cleaning your cooker caution: cleaning of the eco range cooker should only be carried out when the appliance has cooled down. The eco range cooker should be wiped over daily with a damp soapy cloth. The enamel should then be dried and polished with a soft dry cloth to avoid streaking. Any spilla...

  • Page 7

    The warranty will become invalid if you strip and rebuild the cooker yourself. 5.1 site considerations 1. Sufficient space for appliance, so that access for service and maintenance purposes can be easily attained. 2. Provision of a satisfactory flue/chimney/cowl. 3. A sold non-combustible hearth cap...

  • Page 8

    5. With the supplied tape and silicon make a seal on the inner and outer pipes. Push into the cooker, whilst making sure no excess sealant has leaked that may block the cooker spigots. Ensure minimum of 3º drop. 6. With suitable material make a good flue hole. 7. Fit the terminal to the pipes whilst...

  • Page 9

    Burner lockout the burner has an independent control system (burner control box); this includes a flame detector (photocell), which senses the presence of a flame. In the event of a flame failure, the burner control box activates a second re-ignition sequence. Should the photocell not detect a flame...

  • Page 10

    Sound levels should be discussed with the householder, as some people may be sensitive to low noise levels in a small room, as is may appear more annoying than in larger rooms. Please note installation should take into account of flue position (see diagram). Recommended flue position.

  • Page 11

    Oil supply bo il er typical system s ho wn d ia g ram s o f 1win pipe o il s uppl y sys1ems ,-boil er f _ f i re va l.: \ie s e nsor , / / / i al t er na tive f i l ter pos itio n / boil e r oi l tank ..!. Plastic tan k s hjwn stee l tan k a l so sui1ab l a oi l ta nk plastic ta n k shown steel t an...

  • Page 12: Burner Settings

    A flexible oil pipe is supplied to connect the burner to the incoming oil supply pipe. Important notes: - if sitting oil tank above burner height, use single supply pipe only. - if sitting oil tank below burner height, use twin pipe supply or tiger loop. - please refer to burner manual for conversio...

  • Page 13

    Smoke 0 co 2 % 9 - 11.5 flue gas temperature °c 185 electrical power 230/240 v 50 hz fuse 5 amp the hearth the temperature of the surface below the boiler is less than 100°c. If the floor under the boiler is of combustible material, then protection such as steel should be fitted between the boiler a...

  • Page 14

    Qualified engineer, using recognised test equipment and that the regulation of the latest edition of bs 5410, part 1 is read and fully adhered to. The following warranty registration page should be completed by the installer, signed by the customer and returned to eco range cookers. The installer sh...

  • Page 15

    Warranty registration appliance model serial number date of commissioning: customer details customer name: (in block capitals) address: town: county: postcode: customer signature commissioning technicians details technician’s name: (in block capitals) technician’s competent persons oftec registratio...

  • Page 16

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 17

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 18

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 19

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 20

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 21

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 22

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 23

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 24

    Service record appliance model serial number date of service: engineer details engineer's name: (in block capitals) engineers registration number engineer's signature date combustion analysis cooker pump pressure co 2 % co ppm flue gas temperature co/co2 efficiency % engineer's comments: jet changed...

  • Page 25

    This publication or any part of it cannot be copied by any means without the prior written consent of the authors. Our products are subject to continuous development and improvement and it is consequently acknowledged that errors and omissions may occur. This publication is intended only to assist t...