Eco Range ECOFLAM MAX Instructions For Use Installation And Servicing - page 13
SMOKE
0
CO
2
%
9 - 11.5
FLUE GAS
TEMPERATURE
°C
185
Electrical Power
230/240 V 50 Hz
Fuse
5 amp
THE HEARTH
The temperature of the surface below the boiler is less than 100°C. If the floor under the boiler is of
combustible material, then protection such as steel should be fitted between the boiler and the floor.
Consideration should be given to the weight of the cooker, approx 450kG; the floor must provide
adequate support. Please consult the building regulation for safe floor loadings.
CONTROL PANEL
The boiler control panel is factory fitted prior to dispatch.
ELECTRICAL ENTRY
The electrical supply to the boiler must be 230v/50hz, fused at 5 amps. Connection of the appliance and any
system controls, to the mains supply, must be a common isolator and must be fused at 5A maximum.
This must be fixed wired to a double pole-isolating switch that has a maximum contact separation of 2mm in
both poles. The isolator should be clearly marked showing its purpose, and preferably positioned close to the
boiler.
COMMISSIONING & SERVICING INSTRUCTIONS
A competent service engineer OFTEC registered should be appointed on an annual basis.
Isolate Power to the boiler
Inspect and clean burner assembly, and replace with new nozzle (see burner manual)
Replace paper oil filters
Turn electrical supply to the boiler to ON.
Set burner pump pressure.
Allow time for the cooker to reach normal operating temperature.
Check the smoke reading.
Measure the Co
2
Measure net flue gas temperature.
Warranty Registration
G
uarantee
Your cooker now has a one year parts and labour guarantee and a further four year parts guarantee, it is the
responsibility of the installer to ensure that the cooker is properly commissioned. This must be by a qualified
technician. It is essential that the commissioning procedures detailed in this manual are carried out by a