Eco Range ECOFLAM MAX Instructions For Use Installation And Servicing - page 8
5. With the supplied tape and silicon make a seal on the inner and outer pipes. Push into
the cooker, whilst making sure no excess sealant has leaked that may block the cooker
spigots. Ensure minimum of 3º drop.
6. With suitable material make a good flue hole.
7. Fit the terminal to the pipes whilst ensuring the inner pipe has adequate clearance
between terminal end and outlet (min. 50 mm). Secure terminal with supplied screws
and heatproof silicon.
8. The oven vent must then be cut to the correct length, solder tee to pipe with outlets
top and bottom. It is vital that there are no bends in the oven vent.
Warranty on the Cooker structure & castings:
5 Years (Excludes labour)
Warranty on Burner and Controls:
2 Years
CONDITIONS OF WARRANTY:
1. Boiler MUST BE installed by a representative of the company or OFTEC registered engineer, if not
permission will be required by building control.
2. Burner MUST BE commissioned after installation by an OFTEC registered engineer.
3. Burner MUST BE serviced every 24 months after installation by an OFTEC registered engineer.
IMPORTANT CHANGES TO BOILER MANAGEMENT:
Annual Service –This is very important in order to keep the flue ways clean and ensure the boiler is
correctly set.
SWITCHING THE COOOKER OFF
The burner can be switched off at anytime using one of the following:
- Turn the oven control thermostat to the OFF position
- Switch the mains (electrical supply) to OFF
- Set the control system to OFF (e.g. Time Clock)
PLEASE NOTE: For longer periods of shutdown e.g. while away on holiday, switch OFF the mains
(electrical supply) and turn OFF the OIL supply.