Ecobee SMART User Manual - page 12
Minimum On Time This feature allows the homeowner to deter-
mine a minimum time per hour that the furnace fan will run. This
results in increased air circulation and a more consistent tempera-
ture within the home. This is more cost effective than choosing
the ON position for the fan
In either mode, the Smart Thermostat will ensure that when your
vacation ends the thermostat will revert to the regular settings.
Note: If you were running your regular program prior to the start of
your vacation, on your return the Smart Thermostat will restore your
home to those settings. If you were in Hold mode prior to the start of
your vacation, the Smart Thermostat will restore the home to whatever
the set temperature was just prior to your vacation.
UNDERSTANDING
ALERTS
From time to time your ecobee system will display an alert. For ex-
ample, the alert might be a reminder to change the furnace filter,
or perform regular maintenance.
If you have a flood sensor installed in your house the system can
alert you when water is detected, potentially saving you thou-
sands of dollars from damage due to flooding.
If you have enabled the Internet connection to your Smart
Thermostat, these alerts can also be sent to you via e-mail.
When an alert displays, you can dismiss it or ask to be reminded later.
For example, if you receive a furnace filter alert and choose Remind me
later, the alert will clear and display again 24 hours later. If you choose
OK when the alert displays, it will reset the reminder.
19
List of Alerts
Below is a complete list of alerts. Depending on your configuration,
some of these may not apply to your system.
20
Low Battery
Furnace Air Filter
Ventilator Filter
Humidifier Filter
Comms fault
Low Temp. Alert
High Temp Alert
Heat Not
Responding
Cool Not
Responding
Input 1
Input 2
Maintenance
Reminder
Auxiliary Heat
Run Time
Auxiliary Outdoor
Temperature
The battery in your Smart Thermostat will need to
be changed soon.
Your furnace filter needs to be cleaned/changed.
Your ventilator filter needs to be cleaned/changed.
Your humidifier pad needs to be cleaned/changed.
There is no communication between the Smart
Thermostat and the Equipment Interface module.
The temperature in the home is too low.
The temperature in the home is too high.
The system has failed to heat the home.
The system has failed to cool the home.
Used if this input is programmed to generate an alert.
Used if this input is programmed to generate an alert.
You are due for regular maintenance.
Your auxiliary heat source is running too often
your auxiliary heat source is running at higher than
expected outdoor temperatures