ECOLINE TV7091 Installation Instructions Manual - page 15
Operation
System reset and first usage
After connecting all necessary cables startup the system linking by following this proceedure.
The same proceedure is nedded to reset the system:
1.Step: Press the button
SYS RESET .
The LCD displays the following message:
⎥
⎦
⎤
⎢
⎣
⎡
LINKING?
SYSTEM
The LED starts flashing.
2. Step: Press the button
SYS RESET
again.
The system linking will start, search the system connection device and make sure that
all the
connected devices are probably linked.
When the display shows the following message
it means
that an
error has been occurred. In this case refer to step 3, else the camera is ready for the
setup.
⎥
⎦
⎤
⎢
⎣
⎡
RESET
SYS
PRESS
LOST
XXX
:
DEVICE
3. Step: Check the cabeling of the communication cable from the keyboard to the
connected speed dome
cameras. After the power up proceedure of the speed dome, it check the pan and
tilt functionality.
Having checked and sorted the circuit and the speed domes power condition, press
the
button
SYS RESET
again.
Manual control of the speed dome
1. Step: First choose the camera that you want to control. Therefore key in the ID of the
speed dome as a
three digit number, e.g.
0 0 1
for the speed dome with the ID 1.
2. Step: Confirm your ID number by pressing the
ENTER
button
.
The keyboard’s LCD displays:
⎥
⎦
⎤
⎢
⎣
⎡
_
:
001
DEVICE
3. Step: Use the joystick to manually control the spees dome (up, down, left, right, speed)
NOTE: To be able to set up the speed dome’s postition precisely also at a high zoom ratio,
press the
SPEED BY ZOOM
button. The function is activated if the button’s LED is lid. The
function slows down the speed dome’s speed according to the zoom ratio. The higher the
ratio, the slower the dome will move. The function only works for manual control, not when
changing preset positions.
4. Step: Use the buttons
ZOOM TELE
and
ZOOM WIDE
, to set the zoom ratio
accordingly.
15