Ecomax 402 Installation And Operation Instructions Manual - Settings
BA-21907-006-EN 05.10.2015 13
en
6.1. OPen seTTinG MenU
aTTenTiOn:
The machine has to be switched off.
– Open the door.
If the door is closed or if no button is pressed for 30 seconds, the indicator
automatically switches off and the new settings will be saved.Therefore
the setting procedure can be interrupted at any time.
– Push Program buttons
➁
simultaneously.
• LEDs light up.
• In the left display the bottom LED 1 is illuminated.
6.2. adJUsTMenT OF deTerGenT dOsaGe
QUanTiTY
Only with built in detergent pump.
• If the LED 1 is lighted the right display indicates the adjusted
value of the detergent dosage time: one LED corresponds to
approx. 3.5 s ≈ 1 g/l
– Pre-adjusted value: “11−13” = 10.5 s ≈ 3 g/l.
– To adjust the detergent dosage time, push Program button “2”
repeatedly, until the desired value (0−35 s ≈ 0−10 g/l) is indicated.
Adjustment should be done in accordance with chemical suppliers
recommendations.
6.3. adJUsTMenT OF rinse aid dOsaGe QUan-
TiTY
– Push Program button “1” again until
• LEDs 1 and 2 illuminate in the left display.
• the right display indicates the adjusted value of the rinse aid
dosage time: One LED corresponds to approx. 2.5 s ≈ 0,1 g/l.
– Pre-adjusted value: “11−13” = 7.5 s ≈ 0,3 g/l.
– To adjust the rinse aid dosage time, push Program button “2” re-
peatedly, until the desired value (0−25 s ≈ 0−1.0 g/l) is indicated.
Adjustment should be done in accordance with chemical suppliers
recommendations.
6.