Ecomax 402 Installation And Operation Instructions Manual - 3. Start-Up
BA-21907-006-EN 05.10.2015 9
en
3.4. sOFTener (OPTiOnal)
nOTe:
For the first run, the softener has to be filled with regenera-
tion salt and potable water.
attention:
Filling the salt reservoir with cleaning agent will damage the
water softener.
– Open the door.
– Unscrew the softener lid and fill the softener with 1.5 kg of “Granu-
lar regeneration salt” ((2-8 mm) do not use salt tablets).
– Fill up the softener with potable water (only at the first run). Clean
seal and rim of softener lid carefully, before closing the lid.
– Close lid and tighten.
attention:
in order to prevent corrosion it is necessary to remove any salt
residues from tank bottom. after manual removal, start a wash
cycle to completely eliminate any remaining salt residue.
– Adjust the water hardness according to section 6.4. !
When the Salt indicator
➅
flashes during operation, the softener
has to be refilled with regeneration salt.
There will be a slight delay before salt light goes out after refill.
3.5. TanK
For machines without pressure pump and connected to cold water supply
it is recommended to run a one off filling and draining of the wash tank
by following instructions of section 4.1 and 5.1.