Ecomax F504 Installation And Operation Manual - Ecomax
9
Display of faults and information
9.1
Error
▶
"Er" appears in the top display.
3
5
8
7
7
6
2
1
▶
The error code is shown in the bottom display (see table).
Error code
Reason
Remedy
01
Boiler sensor temperature exceeds setpoint.
Contact your HOBART Service Partner.
02
Boiler sensor temperature below setpoint.
Contact your HOBART Service Partner.
03
Hot water tank thermostop in wash programme. Contact your HOBART Service Partner.
05
Tank sensor temperature exceeds setpoint.
Contact your HOBART Service Partner.
06
Tank sensor temperature below setpoint.
Contact your HOBART Service Partner.
07
Total value of pressure sensor for boiler excee-
ded.
Contact your HOBART Service Partner.
08
Total value of pressure sensor for boiler below
setpoint.
Contact your HOBART Service Partner.
09
Total value of pressure sensor for tank excee-
ded.
Contact your HOBART Service Partner.
10
Total value of pressure sensor tank below set-
point.
Contact your HOBART Service Partner.
12
Water level regulation in wash tank failed.
Contact your HOBART Service Partner.
13
Filling programme monitor pressure sensor tank. Pump out machine.
14
Wash tank draining in pump out programme for
pressure sensor tank.
Clean the drain hose if necessary and pump-out
the machine again.
17
Filling monitoring by impeller sensor.
Check water supply.
18
Filling monitoring by measuring the water level
in the boiler.
Check water supply.
28
Fill level of wash tank too low at programme
start.
The machine fills up independently and starts
the program. If the error message persists,
inform your HOBART Service Partner.
29
Capacity of external water treatment unit
exhausted.
Replace part or full desalination cartridge.
31
Filling monitoring
Check water supply.
Contact your HOBART Service Partner.
ECOMAX
Display of faults and information
HOBART
0000000235-001-EN / 04. Jul. 2017
27
EN
Installation and Operation Manual