Economix Zlin Z-526 AFS Instruction Manual - page 7
1mm
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between the rudder
and tail edge.
Epoxy the pivot & round hinges to the rudder,drill holes to appropriate
position in the rudder and assemble the tail landing gear to it as shown.
According to the illustration below bend the tail landing
gear wire and cut off the surplus part.
Epoxy the rudder to the vertical fin..
Assemble the tail landing gear to tail fuselage as below.
Rudder
Make sure hinges are
mounted in the same line.
45mm
25mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
TP Screw (2.3x12mm)
40mm
25mm
Trim a slot and drill a hole in the rudder for helping
assemble the tail landing to it.
3mm
22
21
8
24
23
26
25
The standard sketch map when the kit install completion.
Assemble the wheel to the retracts.
Assemble the retract.
1
wing joiner (25x700mm)
2
Washer (6x12mm)
2
Screw (6x35mm)
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
8
TP Screw (3x20mm)
Lock Nut(4mm )
Lock Nut(4mm )
2
2
Wheel(100mm)
Wheel(100mm)
8
TP Screw (3x20mm)
Insert the main wing joiner to one side of the lower wing.
Main wing joiner (16x499mm)
1
Main wing joiner (25x700mm)
Apply instant type AB glue to the control horn and the slots in
the aileron, insert the control horn to the slots as illustration.
6
7
8
9
10
5
Accessory list for the coming installation steps.